kinhinbeta

Appearance

Report an issue

How to run Gitea or Forgejo Actions on a Mac ​

Gitea and Forgejo use the same runner, so kinhin sets them up the same way. Add a Gitea or Forgejo account to your config, then send jobs to the Mac with a label. Each job gets a fresh VM, and kinhin deletes it after the runner goes idle.

Set it up ​

Install kinhin and start the fleet as in How to run GitHub Actions on a self-hosted Mac. Then add the account:

yaml
accounts:
  - name: gitea # or "forgejo" with forge: forgejo
    forge: gitea
    instance: "https://gitea.example.com"
    scope: "owner/name" # or an org name
    labels: ["macos:host"] # jobs opt in via runs-on: macos:host

The token is an access token with runner-management rights on the scope. Store it with kinhin auth set --gitea or kinhin auth set --forgejo.

In the workflow, ask for the Mac by its label:

yaml
jobs:
  build:
    runs-on: macos:host

Minimum runners depend on the version ​

Gitea 1.24 and older report no queued job until a runner exists, so set min_runners: 1 for them. Gitea 1.25 and later, and Forgejo 11 and later, list queued jobs themselves and work with min_runners: 0.

kinhin has run end to end on Gitea 1.24 and 1.26 and on Forgejo 11. See the tested-forge table.

The runner has no single-job mode, so kinhin deletes the VM shortly after its runners go idle.

Next steps